Be sure to consult our Buyer's Guide & Fakes Database before purchasing a carousel figure. Each day, more and more knock-offs come on the market. Some look old but looks can be deceiving. Become an informed buyer.
After a few rebuilds on the stack, the screw holes in the deck board
which serve to attach the valve board to the pneumatic deck board get
stripped out. It is tempting to use a larger screw to get another bite on
the stripped holes. Doing this without first enlarging the hole on the
valve board can cause the wood to split between the holes in the valve
board. The result is a crossover vacuum leak between the two adjacent
pneumatics. If the leak is bad enough, the adjacent pneumatic will
operate and two notes will play at the same time. To repair this and use
the valve board again, we use a vertical mill to route out the wood
around the screw holes. New wood is glued in place. PHOTO A.
WURLITZER CALIOLA RESTORATION (Part 12)
MORE WORK ON THE PNEUMATIC STACK
by Dr. Bill Black
In PHOTO B, the new wood repair has been sanded flush with the face of
the board and new holes drilled large enough to accommodate the new
screws without splitting the wood.
In PHOTO C, the valve unit board has been sanded, refinished and the
leather gaskets for the metal valve units have been attached to the board
with shellac. The brass nipples have also been removed, cleaned and
reinstalled with shellac to seal the joints.
PHOTO D. The metal valve units are being assembled and screwed to the
board. After they have been attached, the excess pouch leather is trimmed
with an exacto knife. Before the valves were assembled, the metal parts
were cleaned and sprayed with a light coat of spray paint called Detail
Gray. This product is sold by EASTWOOD who makes things for the
automobile restoration folks. This paint produces a finish which looks
like a fresh metal casting. Very nice look..
PHOTO E shows the finished valve portion of the pneumatic stack. Next we
will recover the pneumatics. PHOTO F shows the old pneumatics on the deck
PHOTO G. After the removal of the old pneumatics, a section of old
newspaper is uncovered. The previous restorer used this newspaper between
the pneumatics and the deck board. I tried to preserve this as best I
could until I could see if there would be any information as to dates
and locations giving clues as to where the machine had been in the past.
But, no dates could be found, just a lot of advertisements. Still there
was some useful information. There were references to Shipshawana and
LaGrange, both in Indiana. Also, US Route 20 which runs thru there. Ads
for one half gallon of ice cream for 59 cents, 2 loaves of bread for 39
cents. These prices would be in the 1960s era and perhaps the restoration
work was done in Indiana around that time. When the cover for the access
hole in the vacuum pump reservoir was previously removed there was also
some newspaper visible. As mentioned before there were no dates but there
were several mentions of a town called Penn Hills and Pennsylvania. This
town is located in the Pittsburgh PA area. Perhaps the pump work was done
later in that area sometime after the stack work was done. After getting
the info from the newspaper, it was removed from the deck board.
Dr. Bill Black is one of the nation's most knowledgeble Wurlitzer band organ experts. He has made recordings of many band organs and other mechanical music machines which are available for purchase in our Gift Shop .
Articles, photos and other carousel and/or amusement park related content always needed. If you have something you would like published on this website please contact us at the email address below.|
©1995-2016 - Zubee Internet Services. All rights reserved. Carousels.com, CarouselNet.com, Carouselstores.com, Carouselstores.net, CarouselsNet.com, CarouselsOnLine.com and CarouselResources.com are the property of Zubee Internet Services and may not be used without written consent from same. Images, text and all other components of this site may not be used without express written permission from the site owners.